Sima XL-8 Owner's Manual download pdf (Page 6)

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Page 6 of 20 Max-Flo XL Pump IS2300 Rev-A1

2. General Information

2.1. Introduction

This manual contains information for the proper installation and operation of the Hayward Max-Flo XL Series. The

instructions in this manual MUST be followed precisely. Failure to install according to defined instructions will

void warranty.

2.2. Primary Features

 Aligns with the original Max-Flo pump for seamless retrofit installations.

 Advanced hydraulics for increased efficiency and priming ability.

 All models include 1 1/2” x 2” union connections.

 See-through strainer cover lets you see when the basket needs cleaning and seals with less than a quarter turn.

 Pressure testable to 50 psi maximum.

 Optional riser base available to align with Sta-Rite® Dyna-Pro®.

 Self-priming (suction lift up to 8’ above water level)

2.3. Product Dimensions

3. Installation and Wiring

WARNING – This product should be installed and serviced only by a qualified professional.

3.1. Pump Location

Locate pump as close to pool as practical and run suction lines as direct as possible to

reduce friction loss. Pump height location should be as close to pool water level as

possible and NOT to exceed 8 feet. Suction lines should have continuous slope upward

from lowest point in line. Joints must be tight (but not over-tightened). Suction line

diameter must equal or be larger than the discharge line diameter.

Single Speed

Dim "A"

0.75

10.8"

1 11.3"

1.5 12.4"

2 12.5"

Dual Speed

Dim "A"

1 12.0"

1.5 12.5"

2 13.0"

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

Sima XL-8 Owner's Manual Page 6