Sima CP-150 User Manual download pdf (Page 15)

Appendix A

Procedure for Hard Drive installation on the CP-150

This procedure is to be used when installing your own hard drive in the CP-150

1. Remove unit from packaging.

2. Remove the four case screws from the back of the CP-150.

3. Remove metal U-shaped hard drive bracket from CP-150 circuit board.

4. Set CP-150 aside until the hard drive is ready.

5. Remove the hard drive from protective bag.

6. Note: Take care on the handling of the hard drive. It is very sensitive and

can be damaged with improper handling. Touch only the sides of the hard

drive, do not touch the printed circuit board.

7. Make sure that the drive jumper is set to Master only. Sometimes called

Master/No slave. Refer to the diagram on the hard drive.

8. Attach the U-shaped bracket to the sides of the hard drive using the

included screws but do not tighten.

9. Place the hard drive on top of the circuit board of the CP-150 and carefully

line up the IDE connector to the pins located on the back of the hard drive.

10. Gently slide the hard drive into the connector on the CP-150. NOTE: be

careful to not bend or damage the pins on the hard drive. Also make sure

that the pins are lined up correctly with the connector on the CP-150

11. After the hard drive is seated in the IDE connector, reattach the U shaped

bracket to the circuit board of the CP-150 and tighten all 4 screws located on

the hard drive bracket.

12. Reassemble the case halves of the CP-150 and proceed to the formatting

section of this manual.

1 2 ... 10 11 12 13 14 15 16 17

No comments

Sima CP-150 User Manual Page 15